Fitting Instructions - GaraMat

Decide on the position for installing the GaraMat in the garage. The GaraMat must be installed with the logo and white border facing upwards. Installing
upside down will result in reduced performance and void your product warranty.

Clean the installation area with a dustpan and brush/broom to remove any leaves, stones, dust, debris, water, oil, and grease prior to fitting. If the
floor is painted, use a wire brush to remove any loose paint and provide a good surface for the adhesive hook-and-loop fasteners to bond to
properly. Be sure to remove any dust or debris after doing so.

Mark the floor around the four corner edges of the GaraMat.

Fold up one corner of the mat and place a floor hook-and-loop fastener on the floor approximately 2” (50mm) inside the marks you made around the
edge of the mat. Then draw around the edges of the hook-and-loop fastener and remove.

Using an alcohol pad, wipe floor inside the marked area where the
hook-and-loop fastener will go.

Once the liquid from the alcohol pad has completely dried, remove the plastic sheet from the back of the hook-and-loop fastener and then place the
fastener onto the marked area on the floor and push down hard to ensure it is stuck down well.

On the over-turned corner of the mat, place a hook-and-loop fastener on the underside of the mat corner approximately 2” (50mm) from the edge. Draw around the hook-and-loop fastener and then remove.

Using the alcohol pads, wipe inside the marked area where the hook-and-loop fastener will go.

Ensure the liquid from the alcohol pad is completely dry. Then remove the plastic sheet on the back of the hook-and-loop fastener and place the fastener
onto the marked area on the back of the mat and push down hard to ensure it is stuck down well.

Repeat steps three to nine for each of the other three corners of the mat.

Line up the corners on the mat so that the floor and the mat hook-and-loop fasteners line up and then push down to secure in place.

Drive the vehicle onto the GaraMat ensuring that it is in the middle of the parking mat and
that neither the front nor the back of the car is overhanging the mat.

When you are happy with the position of the car on the GaraMat, place a GaraStop in front of the front left tire and then place the other GaraStop in front of the front right tire, ensuring that the tire is in the middle of the GaraStops. Then reverse the vehicle off the GaraMat.

Using a tape measure, measure the distance between the GaraStop and the front white line
on the GaraMat. Do this at both ends of the GaraStop to check both measurements are the same and the GaraStop is straight. – this can also be done using a spirit level instead.

Using a tape measure, measure the distance between the left
GaraStop and the left side white line on the GaraMat, and make
sure the measurement is the same for the right side GaraStop. This will check that the position
of the GaraStops are symmetrical.

Mark around both GaraStops with a marker pen.

Remove the GaraStop and then
clean the area where you want
the GaraStop to be placed.

Once the area is completely dried, peel off the backing paper on the bottom of the GaraStop and then place the GaraStop onto the marked location and push down firmly. Repeat with the second GaraStop.